SCHEDULE SERVICE           CALL 503-231-0444
MBI Motors
  • Home
  • Meet Our Team
    • About
  • Services
    • Mercedes Benz
      • Mercedes Benz A Service
      • Mercedes Benz B Service
    • Mercedes Metris
    • BMW
    • Smart Car
    • Mini Cooper
    • Alignment
  • Specials
  • Testimonials
    • Gallery
  • Parts
  • Financing
  • Articles
  • Contact
  • Click to open the search input field Click to open the search input field Search
  • Menu Menu
  • Link to Facebook Link to Facebook Link to Facebook
  • Link to Yelp Link to Yelp Link to Yelp
  • Link to Youtube Link to Youtube Link to Youtube

Is Your Older Mercedes Leaking After Storage?

mercedes transmission fluid leak

(not a 560SL, we know)

When a classic Mercedes sits unused for a couple of years, fluid seeping from the engine compartment might point to seals and gaskets that have stiffened up. Instead of topping off the fluids and driving, we suggest finding the source and fixing it.

We did this with a beautiful 1988 560 SL that had been sitting in storage for two years. We found fluid escaping at the oil pan and rear servo cover. But that wasn’t the only problem. The timing chain needed replacing, the brake fluid had absorbed moisture, and the tires weren’t safe to drive on. Our team at MBI Motors went to work replacing the transmission oil pan gasket, rear servo cover O-ring, and primary sealing ring, flushing the fluid, swapping the timing chain and tensioner, restoring the brake hydraulic system, and installing new tires with a proper alignment. This classic Mercedes now runs safely and is back to being a daily driver.

  • Issue: Fluids seeping from an older Mercedes after two years of storage
  • Root Cause: Seals and gaskets that stiffened from sitting without fluid circulation
  • What Happened: Related age issues also turned up in the engine, brakes, and tires
  • What We Did: Replaced the transmission seals, timing chain and tensioner, flushed the brake system, and installed new tires with an alignment
  • Where: MBI Motors in Portland
  • Result: Classic vehicle restored to safe, reliable operation

Have You Noticed These Symptoms in Your 1980s Mercedes?

If your classic Mercedes has been sitting in storage, you might spot fluid pooling underneath it or notice a burning smell on startup. These can be signs that transmission seals have started to break down from age or sitting unused. When a car sits for a long time without the engine running, gaskets and O-rings can get stiff and brittle, and without fluid moving through them, they may begin to leak, often at the oil pan and rear servo cover. Stored vehicles can show other warning signs around the same time. Keep an eye out for:

  • Hard starting or rough running at idle
  • A soft or spongy brake pedal
  • Tires with visible cord showing or uneven wear

Extended storage affects several systems at once. Seals can wear down, moisture can work its way into brake fluid, and tire rubber can harden and crack. Our customer’s 560 SL had been parked for two years, and that may have contributed to problems showing up in the transmission, engine, brakes, and tires all around the same time. Catching these symptoms early could help you address them before they affect how safe the car is to drive.

What We Found

Once we got the transmission open, we traced the leak to two points: the oil pan and the rear servo cover. That told us the problem went beyond a simple fluid loss, so we planned to replace the rear servo cover O-ring, the primary sealing ring, and the oil pan gasket.

The rest of the car told a similar story. The timing chain and rail showed enough wear that we recommended replacing them along with the tensioner, to help avoid more serious engine damage down the road. We also found valve cover gaskets, spark plug wires, and distributor cap components that could use replacing to help the ignition timing perform as expected, and we noted a chance to upgrade the alternator pulley and belts for the charging system.

On the brake side, the fluid showed signs of moisture contamination, which is common in a car that’s sat for a long stretch — brake fluid can naturally draw in water from the air over time. The tires were worn badly enough, with exposed cords and uneven wear, that they may have pointed to alignment issues that developed while the car sat.

How We Fixed this 560 SL

  1. Drained and flushed the transmission fluid to help clear out contaminants that built up during storage
  2. Replaced the transmission oil pan gasket, rear servo cover O-ring, and primary sealing ring, one sealing point at a time
  3. Replaced the timing chain and rail along with a new tensioner assembly
  4. Replaced the valve cover gaskets, spark plug wires, and distributor cap components
  5. Upgraded the alternator pulley to a new billet unit and installed fresh serpentine belts
  6. Flushed the non-SBC brake system to clear out moisture contamination
  7. Installed four new Continental tires and performed a full wheel alignment
  8. Took the car on a road test and ran a multi-point inspection to check transmission pressure, engine performance, brake response, and tire wear

What Should I Do If My Stored Mercedes Is Leaking Fluid?

If you notice fluid pooling under your classic Mercedes after it’s been sitting, it’s worth getting it inspected soon by someone familiar with classic cars. Extended storage can cause gaskets and O-rings to stiffen and lose some of their sealing ability, which may lead to leaks at points like the oil pan and rear servo cover. Driving it before it’s checked could risk further damage. We’ve worked through this kind of issue in other stored Mercedes models at MBI Motors.

How Does Extended Storage Affect Seals and Gaskets?

When a car sits unused for a long stretch, transmission seals and gaskets can gradually stiffen and become brittle as the rubber hardens without fluid moving through and engine heat to keep it flexible. This can happen at more than one sealing point at the same time — the oil pan gasket, rear servo cover O-ring, and primary sealing ring may all be affected. Without regular driving, the fluid may not stay at the temperature and pressure it needs to, which can speed up seal wear. This is one reason stored vehicles may need new seals rather than just a fluid top-off. We’ve often seen this pattern in cars that sat for more than a year without being driven.

What Can I Expect During a Transmission Leak Repair?

A typical repair starts with draining and flushing the fluid to clear out anything that built up during storage. From there, we replace the oil pan gasket, rear servo cover O-ring, and primary sealing ring, addressing each sealing point individually. The process wraps up with a road test and a thorough inspection to confirm transmission pressure and overall performance meet our standards. A comprehensive restoration can help you avoid more expensive internal damage later and can help your classic Mercedes last longer.

How Can I Prevent Transmission Leaks During Storage?

To help keep seals from breaking down while your car sits, try to keep the fluid topped off and run the engine occasionally to keep fluid moving and seals flexible. Storing the car somewhere with a steady temperature can also reduce stress on rubber parts. Changing the transmission fluid and filter before long-term storage can help clear out moisture and contaminants ahead of time, and checking the sealing surfaces yearly can help catch small leaks before they grow. These steps can meaningfully reduce the chance of seal failure while the car sits. If you’re storing the car for more than three months, running the engine periodically can help.

Get Your Stored Mercedes Up To Speed Today

If your classic Mercedes is in the Portland, OR area and has been sitting or you’re dealing with transmission leaks, brake issues, or worn tires, reach out to us. MBI Motors is located in Portland, with licensed, insured technicians and transparent pricing before any work begins. We can provide a diagnostic inspection and get your restoration started. Call us at 503-231-0444 or fill out a contact form to get your vehicle running safely and reliably again.

Categories

  • BMW
  • MBI Motors News
  • Mercedes
  • Mercedes Metris Van
  • Mercedes Smart Car

Office

Address
1309 SE Hawthorne Blvd
Portland, OR 97214

Phone
503-231-0444

Hours:
M-F: 7:30AM–5:00PM

CONTACT US

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

This contact form is deactivated because you refused to accept Google reCaptcha service which is necessary to validate any messages sent by the form.
google maps listing

MBI Motors

Address: 1309 SE Hawthorne Blvd Portland, OR 97214

Schedule a Repair

Hours

Mon-Fri: 7:30AM–5:00PM

CALL US: 503-231-0444

Copyright | MBI Motors
  • Link to Facebook Link to Facebook Link to Facebook
  • Link to Yelp Link to Yelp Link to Yelp
  • Link to Youtube Link to Youtube Link to Youtube
Link to: Understanding BMW X1 Propeller Shaft Flex Disc (Guibo) Failure Link to: Understanding BMW X1 Propeller Shaft Flex Disc (Guibo) Failure Understanding BMW X1 Propeller Shaft Flex Disc (Guibo) Failurecracked-guibo-flex-disc Link to: Why Your Smart ForTwo Won’t Charge: What We Found Link to: Why Your Smart ForTwo Won’t Charge: What We Found smart-fourtwo-charging-error-facebookWhy Your Smart ForTwo Won’t Charge: What We Found
Scroll to top Scroll to top Scroll to top